[Firehol-support] message from xt_physdev when running firehol in bridge configuration

[Tsaousis, Costa]

Hi Phineas,

Can you trace it down?  Are you using physin/out on non-bridged traffic only?
Try to run a few commands by hand to check which ones complain.

Regards,

Costa



On Tue, Nov 18, 2014 at 3:59 PM, Phineas Gage <phineas919 at gmail.com> wrote:
> Hi,
>
> I’m getting this message many times in my syslog when running firehol:
>
> xt_physdev: using --physdev-out in the OUTPUT, FORWARD and POSTROUTING chains for non-bridged traffic is not supported anymore.
>
> This happens only when I use either the ‘physin’ or ‘physout’ keywords on either my router definitions or route subcommands for the br0 (bridge) interface. If I omit those keywords it doesn’t happen. Can I still use ‘physin’ and ‘physout’ with my bridge somehow? They’re useful for knowing which direction the traffic is going through the bridge...
>
> Phineas
>
> _______________________________________________
> Firehol-support mailing list
> Firehol-support at lists.firehol.org
> http://lists.firehol.org/mailman/listinfo/firehol-support